New high-performance lifting system for the tinyWASH WT-1 washer-dryer.
 Now with double float switch.
 1x Conventional, mechanical float switch
 1x fully electronic float switch with field monitoring
 The system has 3 inlet connections (1 1/8 inch or 1 1/2 inch, 3/4 or 1 inch, 3/4 inch), which can be used to connect additional devices in addition to the tinyWASH. Dimensions 335mm x 210mm x 110mm. The connection for the waste water hose to the grey water tank is 19mm or 3/4 inch and has an integrated check valve.
 Since the washer-dryer itself does not have a built-in waste water pump, it may be necessary to install a corresponding lifting pump. This is particularly the case if the washer-dryer is to be connected to the grey water tank of the mobile home or camper, but the water outlet of the machine at the installation location is lower than the upper edge of the grey water tank. The lifting pump overpressurizes this height difference up to a maximum discharge head of 1.40 m.
 In most washing programs, the washer-dryer drains the entire water content (approx. 12 liters) from the machine within a good minute. A lifting pump to be installed must therefore have a flow rate of at least 10 to 12 liters per minute.
 This pump system is a fully automatic lifting pump that switches on when water is drained from the machine and switches off again when the water has been pumped out.
 WEEE Reg. No. DE 89158996
 CE